Quick answer: To choose a juice or soft drink filling line, first define the product (juice, nectar, carbonated soft drink or flavoured water), the container size, the target output and whether you need pasteurisation or carbonation. The line is then designed around that: syrup or blend preparation, heat treatment where needed, filling and capping, labelling and packing.
This guide is for investors planning a juice or beverage plant, with lines from Servolines, the Rendat group’s beverage brand. For bottled water, see How to Start a Bottled Water Plant.
When you need a juice or beverage line, not just a water line
- Products that need ingredients blended (concentrate, sugar, flavours, vitamins).
- Products that need pasteurisation or heat treatment for shelf life.
- Carbonated drinks that need CO₂ dosing and pressure control.
- Different containers: PET, glass or cans, depending on your market.
Steps to choose the line
- Define the product: clear juice, nectar, carbonated soft drink or energy drink. Sugar content and acidity affect the product-contact materials.
- Container and output: bottle sizes and output in bottles per hour set the size of the filler and of the blow moulder, or whether you buy ready-made bottles.
- Processing: blending, homogenising, pasteurisation or UHT where needed, cooling, and carbonation for soft drinks.
- Filling and capping: hot, cold or aseptic filling depending on the product, with a tight seal that protects quality.
- End of line: labelling, date coding, shrink wrapping or cartons, and palletising for higher outputs.
- Utilities: steam or hot water, compressed air, cooling and drainage to your local requirements.

General comparison: juice vs carbonated soft drink
| Item | Juice / nectar | Carbonated soft drink |
|---|---|---|
| Preparation | Blending, dilution and usually pasteurisation | Syrup blending plus carbonation |
| Filling | Hot or cold, depending on the recipe | Under pressure with gas control |
| Complexity | Medium to high, depending on preservation | Higher because of the CO₂ system |
| Relative investment | Depends on heat treatment and output | Often higher for the same output |
Exact speeds and pressures are set in the project study; this guide does not give fixed prices or specifications.
How Servolines supports a beverage project
Servolines is the Rendat group’s beverage brand, supplying water and beverage filling lines that cover treatment, blow moulding, filling, labelling and packing, designed around your site. Spare parts are available through RendatSP, and date coding is covered in our laser date printer page (Arabic).
FAQ
Is a water line enough for juice?
Usually not. Juice needs different preparation and heat treatment, and materials suited to the product.
Do I need on-site PET blow moulding?
It is optional and depends on the cost of ready-made bottles and on your output. Many plants blow bottles on site to reduce transport.
Which licences do I need?
They vary by country. Check with your national food authority before installing equipment.
How much does it cost?
There is no single price; it depends on the product, output, automation and building. A quotation follows a review of your requirements.
Request a quotation
Send the drink type, container sizes, daily or hourly output and your country. Request a quote or WhatsApp +86 181 5871 1787.